Albury Development Control Plan 2010

The Albury Development Control Plan (DCP) provides detailed planning and design guidelines to support the planning controls set out in the Albury Local Environmental Plan (LEP) 2010 when designing a development. It contains a number of parts, maps and appendices that you’ll need to refer to depending on your proposed development.

Notation

• As of 26 April 2023 (via State Environmental Planning Policy Amendment (Land Use Zones) (No 2) 2022) a reference to Zones B1, B2, B3, B4, B5, B6, B7, IN1, IN2 in a document should be taken to be a reference to an Employment Zone E1, E2, E3, E4 and supporting zone MU1 (refer to table below)(with the exception of the NEXUS Regional Job Precinct that has been deferred pending further investigation). For further information please see https://www.planning.nsw.gov.au/policy-and-legislation/planning-reforms/employment-zones-reform

*This area was translated to a non-direct equivalent zone.

# B7 Business Park Zone and IN1 General Industrial Zone continue to apply to the NEXUS Regional Job Precinct which has been deferred pending further investigation as part of the Albury Regional Job Precinct Master Plan

• As of 1 December 2021, a reference to an Environment Protection zone E1, E2, E3 or E4 in a document should be taken to be a reference to a Conservation zone C1, C2, C3 or C4. For further information please see NSW Government Conservation Zones Fact Sheet.

• As of 1 March 2022, the NSW Government has consolidated 45 existing State Environmental Planning Polices (SEPPs) into 11 SEPPs based on focus areas. A reference to the former/repealed SEPPs in the Albury Development Control Plan 2010 should be taken as the relevant new consolidated SEPPs, please refer to the guidance on the NSW Department of Planning and Environment’s website Consolidated State Environmental Planning Policies.